Using the Timer
1.
Enter the Timer Mode.
Navigating Between Modes
l
Hour, minute
Seconds
2.
Use the operations below to perform a
timer operation.
D
Start
(Measurement operation starts.)
D
Pause
D
Resume
(Time up)
A beeper will sound for 10 seconds to
●
let you know when the end of a
countdown is reached.
You can reset a paused countdown to
●
its start time, by pressing (B).
3.
Press any button to stop the tone.
Watch Operation Guide 5674
Hand Alignment
Strong magnetism or impact can cause the
time indicated by the analog hands to become
different from the time on the digital display. If
this happens, adjust hand alignment.
Adjusting Hand Alignment
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least five seconds.
Release the button when [SUB] starts to
flash.
This enables adjustment of mode hand
alignment.
After 3.5 seconds
3.
If the mode hand is not aligned with 6
o'clock, use (B) and (D) to align it.
Holding down (B) or (D) scrolls through
●
settings at high speed.
4.
Press (C).
This enables adjustment of the hour and
minute hands.
Hour hand
5.
If the hour and minute hands are not at 12
o'clock, use (B) and (D) to align them.
6.
Press (A) to complete the setting
operation.
Adjustment
After five seconds
Mode hand
Minute hand
Other Settings
This section explains other watch settings you
can configure.
Enabling the Button
Operation Tone
Use the procedure below to enable or disable
the tone that sounds when you press a button.
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
This is the setting mode. The hands
●
automatically shift out of the way for
easy viewing of the display and other
indicators.
3.
Press (C) nine times.
This causes [KEY♪] or [MUTE] to flash on
the display.
4.
Use (B) and (D) to select [KEY♪] or
[MUTE].
[KEY♪]: Operation tone enabled.
[MUTE]: Operation tone muted.
Home City
14