Option Errors (B**) - Riso MZ870 Technical Manual

PANEL MESSAGE

3. Option errors (B**)

Error type B01 [Card counter: No card]
B01-***
Panel display
Insert Card in Key/Card Counter
Error reset
Insert the card.
method
Error point
730
Card counter: No card
Error type B21 [Storage memory: Read/write error]
B21-***
!!System Error!!
Panel display
Turn Main Power SW OFF Then ON
If Recovery has Failed, Call Service
Error reset
Switch power OFF, then ON.
method
Error point
715
Storage memory access error.
Error type B22 [Job separator: Power OFF]
B22-***
Panel display
!! Job Separator is OFF !!
Turn On Power Switch of it
Error reset
Press the Reset key. (Confirm that the job separator is switched ON.)
method
Error point
With the tape separation setting switched ON, the job separator is in a Power OFF state when the Start
721
key is pressed.
The BUSY signal remains at <L> (powe is switches OFF during job separator tape output) for more than 7
727
seconds after the cluster-A signal switches ON.
Error type B23 [Job separator: No-tape error]
B23-***
Panel display
No Paper Tape in Job Separator
Replace Tape Roll
Error reset
Press the Reset key. (Confirm that the job separator is switched ON.)
method
Error point
With the BUSY signal at <H> (Power ON) and the tape separation setting switched ON, the tape detection
722
signal is at <H> (no tape) when the Start key is pressed.
The tape detection signal is at <H> (no tape) after the tape output command is issued, and the BUSY
723
signal changed from <L> to <H> (after completion of operation).
MZ870 / MZ890 / MZ1070 / MZ1090 (Revision 0.9)
Error detecting condition
Error detecting condition
Error detecting condition
Error detecting condition
[ 16-82 ]