Create A New Job, Change Die - GBC Quantum P70iX Instruction Manual

5. Graphical User Interface
CREATE A NEW JOB: Change die set
CHANGE DIESET OR ADJUST PINS
1
P B . 1 4 1
20 HOLES
Selection of a new Die Set will prompt the Die Set screen to come up. This
screen will prompt you to remove the proper Punch Pin numbers for the paper
size you are running. In the example shown, there are two possible pin configu-
rations with this Die Set and Paper combination. The Die Set itself features a
handy reference label to identify the Pin numbers. The Quantum will automati-
cally center the Die Set to the paper size selected if you press buttons 2 or 4. By
pressing buttons 1 or 2, the Quantum will perform all required adjustments (bind
edge, side edge & center the die). You can manually fine-tune the hole centering
by pressing the right-left arrows at this screen.
Note that the pins indicated on the display are the pins that should remain in the
Die Set, i.e. pull the pins to the left and right of the range indicated.
22
PRESS KEY W HEN READY
23
- 2 0 H O L E S
5
P B . 14 1 - 1 9 H O L E S
19 HOLES
0
SHIFT
23
1
ESCAPE
4
7
2 3
5 6
8 9
0 OK