Power Management Setup - ECS RC410-M2 Manual

Hide thumbs

Table Of Contents

Table of Contents

Available languages

Power Mangement Setup

This page sets up some parameters for system power management operation.

ACPI function

ACPI Suspend Type

Hard Disk Power Down Mode

Suspend Time Out

Soft-off by PWR-BTTN

PWRON After PWR-Fail

Power On by Ring

Wake-Up by PCI Card

USB KB Wake UP From S3

Resume by Alarm

RTC Alarm Hour (Hours)

RTC Alarm Minute (Minutes)

RTC Alarm Second (Seconds)

ACPI Function (Enabled)

This item allows users to enable or disable the ACPI power management function.

ACPI Suspend Type (S1 & S3 (STR))

Use this item to define how your system suspends. When you select S3 (STR), the

suspend mode is suspend to RAM, i.e., the system shuts down with the exception of a

refresh current to the system memory.

Hard Disk Power Down Mode (Disabled)

This setting controls how long a hard disk must be left idle before it spins down. The

default is "Disabled".

Suspend Time Out (Disabled)

This sets the timeout for Suspend mode in minutes. If the time selected passes without

any system activity, the computer will enter power-saving Suspend mode.

Soft-off by PWR-BTTN (Delay 4 Sec)

Under ACPI (Advanced Configuration and Power management Interface) you can create a

software power down. If the item is set to Instant-Off, then the power button causes a

software power down. If the item is set to Delay 4 Sec. then you have to hold the power

button down for four seconds to cause a software power down.

PWRON After PWR-Fail (Last State)

This item enables your computer to automatically restart or return to its operating status.

Wake-Up by PCI Card (Enabled)

This option allows the activity of the PCI devices to wake up the system from S3 sleep

state.

USB KB Wake UP From S3 (Enabled)

This option allows the activity of the USB devices to wake up the system from S3 sleep

state.