ECS RC410-M2 Manual page 36

30
CPU Hyper-Threading (Enabled)
This item allows users to enable or disable the CPU Hyper-Threading function.
Press <Esc> to return to the Advanced BIOS Features page.
IDE Configuration (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
IDE Configuration
Parallel ATA IDE Device
SB IDE Controller
Primary IDE Master
Primary IDE Slave
Secondary IDE Master
Secondary IDE Slave
Serial ATA IDE Device
SB SATA RAID BIOS
Third IDE Master
Fourth IDE Master
Fifth IDE Master
Sixth IDE Master
Hard Dsik Write Protect
IDE Detect Time Out (Sec)
ATA (PI) 80Pin Cable Detection
IDE Ultra DMA Mode
F7:Previous Values
SB IDE Controller (Both)
This item enables or disables the integrated IDE controllers. If set to DISABLED, it disables
the integrated IDE Controller, if set to Primary, it enables only the Primary IDE Control-
ler, if set to SECONDARY, it enables only the Secondary IDE Controller, if set to BOTH,
it enables both IDE Controllers.
Primary/Secondary IDE Master/Slave & Third/Fourth/Fifth/Sixth IDE
Master (Not detected) (Press Enter)
Your computer has four IDE channels and each channel can be installed with one or two
devices (Master and Slave). In addition, this motherboard supports four SATA channels and
each channel allows one SATA device to be installed. Use these items to configure each
device on the IDE channel.
SB SATA RAID BIOS (Enabled)
This item enables or disables the SB SATA RAID BIOS function.
Hard Disk Write Protect (Disabled)
Use this item to enable or disable hard disk write protection.
IDE Detect Time Out (35)
This item allows you to set time out for IDE detection.
ATA(PI) 80Pin Cable Detection (Host)
Select the mechanism for detecting 80Pin ATA(PI) Cable.
CMOS Setup Utility - Copyright (C) 1985-2004, American Megatrends, Inc.
IDE Configuration
[Both]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Enabled]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
[Disabled]
[35]
[Host]
[Enabled]
+/-/: Value
: Move
Enter : Select
F8: Fail-Safe Defaults
Using BIOS
Help Item
DISABLED: disables the
integrated IDE Controller.
PRIMARY: enables only
the Primary IDE Controller
SECONDARY: enables
only the Secondary IDE
Controller.
BOTH: enables both IDE
Controllers
F10: Save ESC: Exit
F1: General help
F9: Optimized Defaults