Converting Between Field And Transport Modes; Converting From Transport To Field Mode - Without Road-Friendly Transport - MacDon R1 Series Operator's Manual

11. Close the hitch swing lock-out valve by turning handle (A)
to the closed position (90° angle to the hose).
12. Ensure tires are properly inflated.
13. Ensure the slow moving vehicle (SMV) sign, reflectors, and
lights are clean and visible at rear of rotary disc pull-type.
14. Refer to 3.14.3 Transporting with a Tractor, page 81
transport instructions.

3.14.2 Converting between Field and Transport Modes

Refer to the procedure that suits your equipment and desired transport mode:
• Converting from Transport to Field Mode – Without Road-Friendly Transport
• Converting from Field to Transport Mode – Without Road-Friendly Transport
• Converting from Field to Transport Mode – with Road-Friendly Transport
• Converting from Transport to Field Mode – with Road-Friendly Transport
Converting from Transport to Field Mode – Without Road-Friendly Transport
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator's seat for any reason.
1. Shut down the engine, and remove the key from the ignition.
2. Connect all hydraulic hoses (refer to
wiring harness.
3. Open the steering lock-out valve by turning handle (A) to
the open position (in line with hose).
215333
OPERATION
for
3.7.3 Connecting Hydraulics, page 48
70
A
Figure 3.73: Hitch Swing Lock-Out Valve Shown in
Closed Position
™
, page 70
™
, page 71
™
, page 72
™
, page 78
™
for instructions), and connect electrical
A
Figure 3.74: Steering Lock-Out Valve in Open Position
Revision A