Lubricating Cutterbar; Checking And Adding Lubricant - Cutterbar - MacDon R1 Series Operator's Manual

2. Install curtain (A) into bracket (B).
3. Install two nuts (D) and tighten.
4. Slide bracket (B) into position, and install the square neck
carriage head bolt and flange nut (C).
5. Torque flange nut (C) to 39 Nm (29 lbf·ft).
6. Install four bolts (A), nuts, and large washers to secure
outboard curtain to endsheet. Torque bolts to 39 Nm
(29 lbf·ft).

4.4.3 Lubricating Cutterbar

Checking and Adding Lubricant – Cutterbar
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator's seat for any reason.
WARNING
Exercise caution when working around the blades. Blades are sharp and can cause serious injury. Wear gloves when
handling blades.
215333
MAINTENANCE AND SERVICING
Figure 4.34: Outboard Curtain
Figure 4.35: Left Endsheet
146
A
C
D
A
B
Revision A