Table of Contents
Advertisement
OTHER REDNET SYSTEM COMPONENTS
The RedNet hardware range includes various types of I/O interface and the PCIe/ PCIeR digital audio
interface cards which are installed in the system's host computer or in a chassis. All the I/O units
can be considered as "Break-Out" (and/or "Break-In") boxes to/from the network, and all are built
in mains-powered, 19" rackmount housings, unless otherwise stated. There are also three software
items, RedNet Control 2 (see below), Dante Controller and Dante Virtual Soundcard.
REDNET CONTROL 2
RedNet Control 2 is Focusrite's customisable software application for controlling and configuring
RedNet and Red range interfaces. The system presents an image for each hardware unit, showing
its control levels and function settings, signal meters, as well as critical status indicators for power
supplies, clock status and the primary/secondary network connections.
The operator's manual for the RedNet Control 2 application can be found here:
Please refer to the section 'Device Control' for further details of device operation and setup using the software.
The single-tab image for the RedNet D16R MkII unit is shown below:
The illustration above shows the Gain control sliders, Level meters and the Mute/Dim buttons for
each of the 16 inputs and outputs – the SRCs are not switched in.
Status icons for the PSUs and the network are shown at the left. See next page for icon descriptions.
10
www.focusrite.com/downloads
Advertisement
Table of Contents
