Haier AV08IMVEVA Installation Manual page 9

Installation instruction
Outdoor unit installation
Standard accessories
Please check the attachment is complete, please be sure to use.
No. definition
Installation
1
instruction
4 Rubber plug
5 sheath
6 Reducing pipe
7 wiring harness
8 Wrench
1. Choose a place that can carry the weight of the unit to install and fix, so that the unit will not shake or fall. The unit shall
be installed in a flat area (below 1/100).
2. Do not install the unit in the areas where there may be flammable, explosive, corrosive gas leakage.
3. Indoor and outdoor machines should be close to each other as much as possible to reduce the length of the refrigerant
pipeline and the number of bends.
4. The installation should be to ensure that units from the sun and rain, dust, typhoon, earthquake proof place. In the area
of snow, the machine should be installed in the frame or under the snow cover, so as to avoid the machine snow. See
Figure 1
5. Make sure that there is enough room for maintenance
6. Measures should be taken to avoid contact with children
7. The refrigerant pipe by the unit below should be used when the overhead, overhead part height 200mm above. See
Figure 2
Snow cover (customer buy)
Wind shield (customer buy)
Seasonal wind
The base height should be
considered the maximum
snowfall locally, Prevent snow
height cxceeds the unit angle.
Figure 1
Graphic
(10/12HP) (14HP)
Quantity
1
1 Signal line protection
1 Power line protection
1 Reducing pipe
4 Gas liquid pipe insulation binding
1 Remove service panel
Please use M12 fixed ancher bolts, each machine 4, and use
shock absorbers or shock absorbers to reduce noise
7
Remarks
Figure 2
Place position
Accessory bag
Accessory bag
Accessory bag
Accessory bag
Accessory bag
The outdoor
machine foot
beam
Aerial part
height above
200mm