Haier AV08IMVEVA Installation Manual page 35

Electric wiring and the application
SW1 SW2 SW3
Outdoor
14（E） 15（F） Frequency converter INV1 module temperature
unit
address
15（F） 15（F） Frequency converter INV2 module temperature
0-3
③ System status display and control (host)
SW1 SW2 SW3
0 0
0 1
0 2
0 3
0 4
0 5
0 6
0 7
0 8
0 10（A）
0 11（B）
0 12（C）
0 13（D）
0 14（E）
0 15（F）
④ E2 control parameters display and setting
Each need to be set, setting method:
(1)Press START (SW5) for 2 seconds, display 1111, enter the set state, flashing display the current value
(2)According to UP (SW4) or DOWN (SW7) adjustment parameters
(3)After the adjustment is completed
<A> In the current state of the code, effectively set the time by pressing STOP (SW6) for 2 seconds, showing 0000,
keeping the current settings and exit the set state, stop flashing display, waiting for 2 minutes after the power off and then
re power up
<B> The current set time is not set by STOP (SW6) or change the dial selection, do not save the current set value, exit
the set state, stop flashing display
<C> Effective time setting: the machine with the contract number and set off a low temperature automatic operation
function for 10 minutes, the other for 30 seconds.
function
2 Refrigerant type
The same outdoor unit total
2
number and total capacity
2 Total indoor unit capacity
The indoor units within the
2
same system
Number of indoor unit
2
working
With the outdoor unit running
2 mode the same indoor unit
number
2 Cooling target temperature
2 Heating target temperature
Automatic recovery of
refrigerant
2
Note: the end of the recovery
must be canceled or reset
Test run setup
2 Note: the end of the test run
must be canceled or reset
2 Outdoor unit mode
Indoor unit expansion valve
2
fully open
2 All the indoor unit for cooling Press START (SW5) for 2 seconds, display 1111, fully open；
2 All the indoor unit for heating
Cancel all manual control
2
(running class)
function
410A represents 410A refrigerant
LD1：The total number of outdoor unit
LD2：Display "-"
LD3/ LD4：Total outdoor unit capacity (unit: Horse)
For example: 3-48 said 3 outdoor machines, with a total
capacity of 48 horses
50 represents 50 horses
For example: 64
Temperature sensor ON as a sign of the work of the indoor
unit
For example: 13
Unit: degree
When the outdoor stops, press START (SW5) for 2 seconds,
display 1111, start. (the outdoor is set to work in a state of
operation)
Press STOP (SW6) for 2 seconds, display 0000, stop
When the outdoor stops, press START (SW5) for 2 seconds,
display 1111, start. (the outdoor is set to work in a state of
operation)
Press STOP (SW6) for 2 seconds, display 0000, stop
0-normal C-only cool H-only heat
Press START (SW5) for 2 seconds, display 1111, indoor
valve fully open 2 minutes, 2 minutes after the automatic
shutdown valve
Press STOP (SW6) for 2 seconds, 0000, closed
Press START (SW5) for 2 seconds, display 1111 cancel; or
press STOP (SW6) for 2 seconds, display 0000, cancel
Remove all manual control (part), closed indoor unit
33
Digital tube LD1 ~ 4 display
Unit: degree
Unit: degree
Digital tube LD1 ~ 4 display