Table of Contents
Advertisement
Pause all active alarm-hosts
Pause recording (all recording
modes)
Quit recording pause (all recor-
ding modes)
Start recording camera
(recording mode Contact)
Stop recording camera
(recoding mode Contact)
Live display camera
Disable remote access
(LAN, ISDN, modem)
Enable remote access
(LAN, ISDN, modem)
Dallmeier electronic
DLS 4 / DLS 8 / 8 PLUS / DLS 16 / 16 PLUS
This contact function allows to activate all configured
alarm hosts. This contact function is no counterpart to the
Pause all active alarm-hosts contact function. It does
not matter if the alarm host was deactivated by Pause all
active alarm-hosts or before.
This function allows to stop or pause each active recording
of one or more cameras.
The recording mode of the camera does not play a role
for this function. Recording will be stopped for Permanent
cameras. If the recording mode of a camera is Contact
or Motion detection, the next event will not trigger the
recording.
Which camera is relevant is defined in the Contact Pa-
rameter dialog.
This function starts / activates each recording that was
stopped by Pause recording (all recording modes).
The recording mode of the camera does not play a role for
this function. However, attention must be paid to the fact
that a recording may not occur immediately with recording
modes Contact or Motion detection.
Which camera is relevant is defined in the Contact
Parameter dialog.
This function starts the recording of one camera that is
defined with recording mode Contact.
Which camera is relevant is defined in the Contact
Parameter dialog.
This function stops the recording that is still active (timer
can be expired) that was triggered by Start recording
Camera (recording mode Contact).
Which camera is relevant is defined in the Contact
Parameter dialog.
Display of the images of a camera in the 1x1 split. The
images are also displayed if a display sequence is defined
(via Setup > System > Display > Monitors > Sequencer)
and active.
The duration of the display of that camera depends on
the switching speed, which is set under Setup > System
> Display > Monitors > Sequencer. This means that a
camera is displayed until a switching is triggered manually
or by the sequencer.
Which camera is relevant is defined in the Contact Para-
meter dialog. Every activated camera can be selected. It
does not matter if the camera is connected or configured
for recording.
This contact function breaks all active connections of
applications or users that do not have the right Network
access with contact. New connection requests are
rejected.
This has no impact on users defined as administrators.
This user group has always all rights.
Lifts the restrictions by the contact function Disable re-
mote access (LAN, ISDN, modem).
92
Advertisement
Table of Contents
