System integration
5.2 Navigating the Modbus display menu
5.2
Navigating the Modbus display menu
1. Power up the device. If the device has been installed correctly a new menu entry has
2. Navigate the new menu:
20
appeared in the local user interface of the device (between the "Reset mode" and the
"Service mode" menu entries.)
– Press
for two seconds. The display now says "Basic settings"
– Press
until you reach the "MODBUS RTU module" menu entry
– Press
– Cycle through the MODBUS RTU settings by pressing
Figure 5-1
MODBUS USMII Display menu
.
Operating Instructions, 06/2010, A5E00753974-04
Modbus RTU RS485