Table of Contents
Advertisement
3. INSTALLATION
Before finally installing the unit, connect the wiring temporarily and make sure it is all
properly
and the unit and system work properly.
Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts
can cause malfunctions.
Consult with your nearest dealer if installation requires
vehicle.
Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a
sudden stop, like an emergency stop.
If installation angle exceeds 30° from horizontal, the unit might not give its optimum performance.
Avoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or
from hot air, from heater, or where it would be subject to dust dirt or excessive vibration.
Be sure to remove the front panel before installing the unit.
DIN FRONT/REAR-MOUNT
This unit can be property installed either from "Front" (conventional DIN Front-mount) or "Rear"(DIN
Rear-mount installation, utilizing threaded screw holes at the sides of the unit chassis). For details,
refer to the following illustrated installation methods A and B.
DIN FRONT-MOUNT (Method A)
Installation the unit
1
182
53
1
7
4
2
3
2
3
6
5
drilling
holes or other modifications of the
30°
1. Dashboard
2. Holder
After inserting
the sleeve
select the appropriate tab according to the
thickness of the dashboard material and bend
them inwards to secure the
3. Screw
1. Dashboard
2. Nut (5mm)
3. Spring washer
4. Screw (5x25mm)
5. Screw
6. Support Strap
Be sure to use the support strap to secure the
back of the unit in place. The strap can be bent
by hand to the desired angle.
7. Plain washer
E - 3
connected
into the dashboard,
sleeve
in place.
Advertisement
Table of Contents
