Table of Contents
Advertisement
14.TROUBLE SHOOTING
Before going through the check list, check wiring connection. If any of the problems persist after
check list has been made, consult your nearest service dealer.
Symptom
No power
Disc cannot be
loaded or ejected
No sound
The operation keys
do not work
Sound skips.
The radio does not
work.
The radio station
automatic selection
does not work.
ERROR 1
ERROR 2
ERROR 3
ERROR 4
No File
Disc Error
Cause
The car ignition is not on.
The fuse is blown.
Presence of CD disc inside
the player.
Inserting the disc in reverse
direction.
Compact disc is extremely
dirty or defective disc.
Temperature inside the car is
too high.
Condensation.
Volume is in minimum.
Wiring is not properly
connected.
The built-in microcomputer is
not operating properly due to
noise.
The installation angle is
more than 30 degrees.
The disc is extremely dirty or
a defective disc.
The antenna cable is not
connected.
The signals are too weak.
Mechanism Error
Servo Focus Error
Servo Tracking Error
Motorize Panel Error
No file Format supports for
Playback on the disc
Maybe disc dirty / disc scratched
/disc upside down.
If the power supply is properly connected
to the car accessory terminal, switch the
ignition key to "ACC"
Replace the fuse.
Remove the disc in the player, then
put a new one.
Insert the compact disc with the
label facing upward.
Clean the disc or try to play a new one.
Cool off or until the ambient temperature
returns to normal.
Leave the player off for an hour or so,
then try again.
Adjust volume to a desired level.
Check wiring connection.
Press the RESET button.
Front panel is not properly fixed into
its place
Adjust the installation angle to less
than 30 degrees.
Clean the compact disc or try to play a
new one.
Insert the antenna cable firmly.
Select a station manually.
Press the reset button to correct the problem.
If the error code does not disappear, consult
your nearest service dealer.
Press the reset button to correct the problem.
If the error code does not disappear, consult
your nearest service dealer.
Press the reset button to correct the problem.
If the error code does not disappear, consult
your nearest service dealer.
Press the reset button to correct the problem.
If the error code does not disappear, consult
your nearest service dealer.
Replace the disc.
Replace the disc.
E - 23
Solution
Advertisement
Table of Contents
