Quick Setup; Installation - Aqara SJCGQ11LM Manual

Quick Setup

1. Please add the Hub to the app according to the Hub
Quick Start Guide.
2. Please open the app, tap "Home" and then tap "+" in the
top right corner to enter "Add Device (Accessory)" page.
Select "Water Leak Sensor", and add it according to
instructions.
*If the connection fails, please move the accessory closer to the Hub
and try again.

Installation

Effective Range Test: Single press the reset button on the
accessory at your desired position. If the Hub makes voice
prompts, it indicates that the accessory can communicate
effectively with the Hub.
*Avoid metal surface to maximize signal strength.
Option 1: Place it directly on the surface where you need
to monitor water leak.