Marking And Packing - Belmash SDM-2000 Operating Manual

EN
or other flaws in the wood.
During cross-cutting of round timber, supply the blank by moving it over the table surface,
not by rolling.
Blanks should not be moist. The recommended moisture content is not more than 22%.
The correct working stance of the operator is standing position. To supply the blank, the
operator should stand in off-center position, near the supply point.
While surface planing, move the blank over the table surface pressing it to guiding fence 3f
(figure 1). Doing that, the operator should keep fingers joined and hold the blank on the top
by both hands. The correct hands position: one hand is on the blank's top surface over the
outfeed table, the other hand - on the blank's top surface over the loading table.
Blanks should be planed along the full length not moving it backwards over the rotating
cutter-block. Blanks with a thickness of less than 65 mm should be planed with the usage of
clamping device (not included in package set).
While sawing and milling, blanks should be held with fingers and moved uniform over the
loading table with no tilting. This requires the usage of guide fence 3f and turnable bracket
3e.
Keep your hands in safe distance from cutting point.
Blank supply should be uniform (with no jerking). Supply speed should provide stable
machine operation and prevent its overload.
For short blanks processing (shorter than 300 mm) use the pusher.
There is a plate with information about the parameters of the power supply on the machine
stand. It is recommended to comply with these requirements when connecting the machine
to the network.
It is necessary to observe the symbols on the packaging during transportation and storage.
Consider the tool sizes and do not use adapters for them. Use the tool recommended by
the manufacturer. When working, consider the maximum allowable finished dimensions.
Information on the types of processing is listed on the label on the fencing of the 57 (Fig. 1)
saw blade below the table level.
There is a threat-warning label on the swivel control panel 62 (Fig. 2).
64
7.5 Working stance and blank supply

8. MARKING AND PACKING

Do not put your hands in the working area the machine is switched on.
It may result in risk of injury due to rotating parts.