Manual And Automatic Fax Redial; Dual Access - Brother MFC-8220 User Manual

Manual and automatic fax Redial

If you are sending a fax manually and the line is busy, press
Redial/Pause
make a second call to the last number dialled, you can save time by
Redial/Pause
pressing
Redial/Pause
If you are sending a fax automatically and the line is busy, the MFC
will automatically redial up to three times at five minutes intervals.

Dual Access

You can dial a number, and begin scanning the fax into memory—
even when the MFC is receiving, sending or printing a fax from
memory. The LCD shows the new job number.
If you get an Out of Memory message while scanning the first
page of a fax, press
Out of Memory message while scanning a subsequent page,
you can press
Stop/Exit
1
If it is not illuminated in green, press
original document face down in the ADF.
2
Enter the fax number.
3
Start
Press
The MFC starts scanning the first page and the LCD shows the
job number (#XXX) of the fax. You can repeat Steps 1 to 3 for
the next fax.
, and then press
Start
and
only works if you dialled from the control panel.
Stop/Exit
Start
to send the pages scanned so far, or press
to cancel the operation.
to send the fax.
Start
to try again. If you want to
.
to cancel scanning. If you get an
Fax
( ). Place the
SETUP SEND 6 - 7