FLIR USB3 Vision Flea3 Getting Started

GETTING STARTED
Will your system support the camera?
Recommended System Configuration:
OS—Windows 7, Linux (32- or 64-bit)
n
CPU—Intel Core i3 3.1 GHz or equivalent
n
RAM—2 GB
n
Video—128 MB RAM
n
Ports—PCIe 2.0 compatible host controller with USB 3.1 connector
n
Software—Microsoft Visual Studio 2005 SP1 and SP1 Update (to compile
n
and run example code)
See Technical Application Note 10359
components for USB 3.0.
Do you have a downloads account?
Our downloads page has many resources to help you operate your camera
effectively, including:
Software, including Drivers (required for installation)
n
Firmware updates and release notes
n
Dimensional drawings and CAD models
n
Documentation
n
To access the downloads resources you must have a downloads account.
1. Go to our website: www.flir.com/iis.
2. In the upper right corner, click Register.
3. Complete the form, then click Register.
After you submit your registration, you will receive an email with instructions on
how to activate your account.
Do you have all the parts you need?
To install your camera you will need the following components:
USB 3.1 cable
n
8-pin GPIO cable
n
CS-mount (or C-mount with adaptor)/C-mount (FL3-U3-13Y3) Lens
n
Tripod adapter (optional)
n
Interface card
n
FLIR sells a number of the additional parts required for installation. To purchase,
visit our Accessories page.
Camera Care
To clean the imaging surface of your camera, follow the steps outlined in
Knowledge Base Article 10243.
Extended exposure to bright sunlight, rain, dusty environments, etc. may cause
problems with the electronics and optics of the system.
Avoid excessive shaking, dropping, or mishandling of the device.
Warning! Do not open the camera housing. Doing so voids the Hardware
Warranty.
Avoid electrostatic charging.
1/26/2017
Names and marks appearing on the products herein are either
registered trademarks or trademarks of FLIR Systems, Inc.
and/or its subsidiaries.
© 2011-2017 FLIR Integrated Imaging Solutions Inc. All rights
reserved.
for information on recommended system
Installing Your Interface Card and Software
1. Install your Interface Card
Open the Windows Device Manager. Ensure the card is properly installed under
Universal Serial Bus Controllers. An exclamation point (!) next to the card
indicates the driver has not yet been installed.
2. Install the FlyCapture® Software
Note: For existing users who already have FlyCapture installed, we
recommend ensuring you have the latest version for optimal performance
of your camera. If you do not need to install FlyCapture, use the
DriverControlGUI to install and enable drivers for your card.
a. Login to our downloads page.
b. Select your Camera and Operating System from the drop-down lists and
click the Search button.
c. Click on the Software search results to expand the list.
d. Click the appropriate link to begin the download and installation.
After the download is complete, the FlyCapture setup wizard begins. If the
wizard does not start automatically, double-click the .exe file to open it. Follow
the steps in each setup dialog.
3. Enable the Drivers for the card
During installation, you are prompted to select your interface driver.
In the Interface Driver Selection dialog, select the I will use USB cameras.
This selection ensures the pgrxhci (USBPro) and pgrusbcam drivers are
installed.
To uninstall or reconfigure the driver at any time after setup is complete, use the
DriverControlGUI.
FLIR FLEA®3
USB3 Vision
Ensure the card is installed per the
manufacturer's instructions.
Connect the internal IDE or SATA power
connector on the card to the computer
power supply.
Alternatively, use your PC's built- in host
controller, if equipped.