Troubleshooting - Omcan RE-CN-0045-HC Instruction Manual

Troubleshooting

SYMPTOMS
Compressor will not start
Poor Performance
No Interior Light
Unit Noisy
Condensation on Cabinet and/or Floor
POSSIBLE CAUSE
Check if the power cord has been plugged in.
Check for blown fuse.
Move the unit from direct sun light, and avoid
installing heating devices near the unit.
Install the unit in a well ventilated place with minimum
of 6" clearance in the back.
Check the condenser, and clean if heavy dust is
collected.
Check to see if contents are blocking the air duct.
Check to see if refrigerant charge is low.
Make sure the door is completely closed.
Turn off the light switch and turn it on again.
Make sure the light is correctly inserted into the
sockets.
Check the light, and replace it if blown.
Make sure to install the unit on level surface.
Make sure to maintain the minimum clearance of 6"
from the wall.
Check for the loose parts or mounting.
Make sure the tubing is free from any contact to avoid
tubing rattle.
Reduce the relatively humidity in the area where the
unit is installed.
Gasket on door or head section is not sealing
properly. Repair or replace gasket as necessary.
10