Dip Switches - WEISS GAMBIT ADC2 Operating Manual

OPERATING INSTRUCTIONS FOR GAMBIT ADC2 24Bit / 192kHz A/D CONVERTER

Dip Switches

Fig. 9 Dip switches at the rear of the ADC2
DIP switch summary:
Switch up
1 dual wire on XLR
outputs
2 dither setting affects
all outputs
3 WSYNC input on
BNC NOT terminat-
ed
AES/EBU input NOT
4
terminated
Daniel Weiss Engineering Ltd., Florastr. 42, CH-8610 Uster
+41 1 940 20 06
down
single wire on XLR
outputs (both carry
the same signal)
dither setting affects
only RCA output
WSYNC input on BNC
terminated
AES/EBU input termi-
nated
+41 1 940 22 14 http://www.weiss. ch weiss@weiss.ch
AES OUT DUAL WIRE
If this switch is in the up position, the ADC2 outputs a
dual-wire signal. Refer to Table 2 and Table 3 to look
up exact output configurations depending on this dip
switch.
Sampling DO1
Freq. (XLR 1)
44.1 kHz 44.1 kHz
single wire
48 kHz 48 kHz
single wire
88.2 kHz 44.1 kHz
left channel
96 kHz 48 kHz
left channel
176.4 kHz 88.2 kHz
left channel
192 kHz 96 kHz
left channel
Table 2 AES OUT dual WIRE switch in up position
Sampling DO1
Freq. (XLR 1)
44.1 kHz 44.1 kHz
single wire
48 kHz 48 kHz
single wire
88.2 kHz 88.2 kHz
single wire
96 kHz 96 kHz
single wire
176.4 kHz 176.4 kHz
single wire
192 kHz 192 kHz
single wire
Table 3 AES OUT dual WIRE switch in down position
OPERATION
DO2 DO3
(XLR 2) (RCA)
44.1kHz sin- 44.1 kHz
gle wire single wire
48 kHz 48 kHz
single wire single wire
44.1 kHz right muted
channel
48 kHz muted
right channel
88.2 kHz right muted
channel
96 kHz muted
right channel
DO2 DO3
(XLR 2) (RCA)
44.1kHz sin- 44.1 kHz
gle wire single wire
48 kHz 48 kHz
single wire single wire
88.2 kHz 88.2 kHz
single wire single wire
96 kHz single 96 kHz
wire single wire
176.4 kHz 176.4 kHz
single wire single wire
192 kHz sin- 192 kHz
gle wire single wire
Page 9