Table of Contents
Advertisement
OPERATING INSTRUCTIONS FOR GAMBIT ADC2 24Bit / 192kHz A/D CONVERTER
Low cut frequency response:
1st order highpass, 3dB point at 40Hz
Frequency Response:
@ fs = 44.1kHz: 20Hz ... > 20kHz +- 0.3dB
@ fs = 48.0kHz: 20Hz ... > 20kHz +- 0.3dB
@ fs = 88.2kHz: 20Hz ... > 30kHz +- 0.3dB
@ fs = 96.0kHz: 20Hz ... > 30kHz +- 0.3dB
@ fs = 176.4kHz: 20Hz ... > 40kHz +- 0.3dB
@ fs = 192.0kHz: 20Hz ... > 40kHz +- 0.3dB
THD+N @ 1kHz:
less than -103 dBFS @ -3 dBFs output level, unweighted
SNR @ -40dBFS input:
> 110dB unweighted
Linearity:
t.b.d.
Crosstalk:
< -120dB, 0..20kHz
CMRR:
> 90dB @ 1kHz
> 80dB @ 20kHz
> 60dB @ 20Hz
Interchannel phase tracking:
Better than +- 0.3°, 20Hz to 20kHz
Latency:
sampling rate
delay
44.1k
2.6 ms
48.0k
2.49ms
88.2k
1.8ms
96.0k
1.75ms
176.4k
1.4ms
192.0k
1.38ms
All measurements taken at the least sensitive setting of the input attenuators, i.e. +26dBu sensitivity for line and
+6dBu sensitivity for mic inputs. (= sensitivity for 0dBFS output level).
Daniel Weiss Engineering Ltd., Florastr. 42, CH-8610 Uster
+41 1 940 20 06
+41 1 940 22 14
http://www.weiss. ch weiss@weiss.ch
TECHNICAL DATA
Page 13
Advertisement
Table of Contents
