Tripp Lite B020-U08-19-K Quick Start Manual page 6

4. Basic Operation
4.1 Opening the NetDirector Console KVM
The console is located under the top
cover. To access the console, slide the
console module out and raise the cover.
Note: As a safety precaution, to keep the
console from accidentally sliding out, the console
is locked into the "in" position. Before you can
pull the console module out, first must release it
by pushing the catches on the unit's front panel
toward the center of the switch.
4.2 Closing the NetDirector Console KVM
To slide the console module back in,
close the cover and do the following:
1. Pull the safety catches on the unit's
side rails toward you and push the
module in until it stops.
2. Release the catches; pull the module
slightly toward you; then push it all
the way in.
Note: The purpose of the two-step procedure is
to minimize the chances of pinching your fingers
when sliding the module in.
5. OSD (On-Screen Display) Operation
5.1 OSD Overview
The On-Screen Display (OSD) is a text-based interface that allows for control and
administration of the KVM switch. When logging onto the KVM switch, the OSD Main Menu
is the first screen you will see after entering your username and password.
5.2 Logging In For The First Time
The KVM switch features two-level security, with one Administrator and four User accounts.
If you are an Administrator accessing the KVM switch for the first time, leave the
Username and password field blank and hit the [Enter] key twice to access the OSD Main
Menu. Once logged into the KVM switch as Administrator, you will be able to access all
OSD features and customize KVM settings. At this point, it is highly recommended that you
change the Administrator username and password.
6