Table of Contents
Advertisement
FRONT BRAKE MASTER CYLINDER
Remove the bolts and holder from the master cylin-
der. Align the dot mark on the handlebars with the
master cylinder-to-holder fitting surface. Install the
spacer between the throttle housing and master cylin-
der holder. Tighten the master cylinder mounting
bolts to the specified torque.
Front brake master cylinder mounting bolt:
10 N·m (1.0 kgf-m)
NOTE: To install the holder correctly, first
tighten the bolt B B B B of the upper side with speci-
fied torque and then tighten the bolt C C C C of the
lower side.
A: Holder
B: Bolt
C: Bolt
When squeezing the brake lever no contact
the throttle housing.
NOTE:
Install the holder in position according to the
mark "UP".
Make sure that the holder has no clearance at
the upper side as shown.
Check for brake fluid leakage.
A: Bolt
B: Holder
Connect the front brake light switch lead wires cou-
pler to the brake light switch.
A: Front brake light switch
B: Lead wire coupler
Install the front brake hose to the brake hose guide
with the protector properly in place.
A: Front brake hose
B: Brake hose guide
C: Protector
D: Recess
9
D: Spacer
E: Dot mark
F: Throttle housing
C: Master cylinder
D: Handlebars
Advertisement
Table of Contents
