Mounting The Attachment - Stihl FS Instruction Manual

English
Securing the Loop Handle
A
9
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommendation: distance (A):
about 20 cm (8 in)
Slide the handle to the required
N
position.
Line up the loop handle (4).
N
Tighten down the screws until the
N
loop handle can no longer be
rotated on the drive tube. If no
barrier bar is fitted – lock the nuts if
necessary.
The sleeve (9) (not fitted on all models)
must be between the loop handle and
the control handle.
46

Mounting the Attachment

Preparations for Mounting the
Attachment
WARNING
To reduce the risk of injury, always shut
off the engine before converting the
4
basic power tool.
NOTICE
Make sure the work area is clean before
mounting or removing the attachment.
Rest the power tool on the machine
N
support.
Removing the protective cap
If a cap is fitted on the end of the power
tool's drive tube:
Pull the protective cap off the end of
N
the drive tube and keep it in a safe
place.
If the plug comes out of the drive tube
when you pull off the cap:
Push the plug into the drive tube as
N
far as stop.
Removing the gearbox or attachment
Remove any existing gearbox or
interchangeable attachment from the
basic power tool.
BF
FCS
FS