Approved Multiengines; Mounting The Multitool - Stihl KB-MM Instruction Manual

Approved MultiEngines

Only use MultiEngines supplied by
STIHL or expressly approved by STIHL
for use with the MultiTool.
This MultiTool may only be used in
combination with the STIHL MM 56
MultiEngine.
KB-MM, KW-MM

Mounting the MultiTool

Removing Existing MultiTools
WARNING
Wear gloves to reduce the risk of injury
from contact with sharp MultiTools
and/or hot surface of gearbox.
Remove the hitch pins and pull the
N
MultiTools (if fitted) off the axle –
see also "Mounting the MultiTool" in
the instruction manual of the other
MultiTool.
Clean the gearbox if necessary.
N
Checking Position of Gearbox
WARNING
To reduce risk of injury from the
MultiTool rotating in the wrong direction,
check that position of gearbox is correct
and adjust if necessary.
The axle (1) must be above the shaft (2).
Direction of rotation (3) of MultiTool.
Adjusting Position of Gearbox
Loosen clamp screws on gearbox.
N
Turn the gearbox through 180°.
N
Line up the gearbox in the correct
N
position.
Tighten down the two clamp screws
N
on the gearbox in the following
sequence:
Tighten the first screw moderately.
–
Tighten the second screw
–
moderately.
Tighten down first screw firmly.
–
Tighten down second screw firmly.
–
English
9