Advertisement
4. The radio is attached to the dash bezel,
using a panel removal tool lift away,
disconnect harness, and remove the
radio from its location (4).
5. Next, follow the steps below in the
order listed A, B & C (see illustration for
corresponding visual reference).
A. Set the parking brake on.
B. Drop gear to a lower gear (Neutral)
C. Use a panel removal tool remove
panel surrounding the gear shifter.
6. Lastly, carefully reach into the radio
dash cavity and unplug the 12v power
from location and proceed to next steps
(Testing Qi Module/Preparation)
TESTING QI MODULE (MQUSM)
Testing Connection: Before proceeding to the
preparation/installation please test the modules
functionality by connecting the provided vehicle
specific I-harness (diagram on right). Once the module
Is connected, place the QI-enabled device on the
module and refer to the LED Status chart
below for specifics. For technical assistance
with the installation please call or visit us on
thewebat1-800-363-4490x1
www.scosche.com/contact
NOTE: The module can also be tested
by connecting it to a USB to type-c
connection power source (not included).
VEHICLE DISASSEMBLY
Female Connector to
♦
12V h
♦
�
Male Connector to
Back of 12V Socket
5
a e
c nne
cto
m ss o
�
w��
To QI Module
(MQUSM )
r
i--c:::n
Advertisement
