Siemens SIPART PS100 Compact Operating Instructions page 19

4. If you use a short lever, the carrier pin is already premounted. If you use the long lever
6DR4004-8L, fasten the carrier pin
Figure 4-3
Figure 4-4
5. Position the carrier pin on the stroke value of the upper scale (90) of the lever
greater than 35 mm, use the long lever, article number 6DR4004-8L.
6. Push the pre-installed lever
with cylinder head screw
7. Install the mounting bracket
spring lock washers
Figure 4-5
8. Select the row of holes. The selection of the row of holes depends on the yoke width of the
actuator. Select the row of holes in such a way that the carrier pin
up bracket
clamping pieces
SIPART PS100
Compact Operating Instructions, 05/2021, A5E50188940-AA
Short lever
Long lever 6DR4004-8L with mounted carrier pin
⑥
up to the end stop on the positioner shaft. Fasten the lever
⑰
.
①
at the rear side of the positioner. Use 2 hexagon bolts
⑩
and 2 flat washers
Installation with mounting bracket
②
near the spindle. Ensure that the pick-up bracket
③
.
④
with the existing parts to the long lever.
④
⑪
for this.
Installing/mounting
4.2 Mounting to linear actuator
and cylinder head screw
⑥
. For strokes
④
meshes with the pick-
②
does not touch the
⑰
⑥
⑨
, 2
19