Advertisement
6 Battery replacement
a) If the battery symbol ``+/-``appears on the display, batteries should be replaced.
b) The battery cover 3-4 has to be removed from the instrument and the batteries
have to be taken out.
c) Batteries (4x1.5V AAA/UM-4) have to be installed, paying carefully attention to
polarity.
d) If the instrument is not used for a longer period, batteries should be removed.
7 Adjustment foils
As accessory there is included a foil set of different adjustment foils, which always
cover the measurement range from 20 to 2000µm. It is also available as a spare part,
article ATB-US07.
8 Trouble shooting
a) The instrument should always be adjusted on the uncoated base material to be
measured instead of the base plate included in the delivery. Then the accuracy is
more precise.
b) Sensors will eventually wear off. Life of the sensor will depend on the number of
measurements taken and how abrasive the coatings are.
9 Restore Factory Settings
a) It is recommended to restore factory settings in following cases:
-
The instrument does not measure any more
-
Measurement accuracy is degraded caused by drastic environmental changes
b) How to restore:
To restore factory settings includes both, "Fe" setting and "NFe" setting. Please note
which symbol is shown on the display.
You can restore only one of them or both respectively. Please follow the procedure
below:
- Press the Power key and do not release it until "CAL" appears on the display. OFF,
UNIT, SC and the CAL will appear in sequence. CAL appears about 6 seconds from
starting to press the Power key.
F:H or nF:H will be displayed after releasing the Power key.
Place the sensor (3-1) onto the corresponding base material steadily.
Then press the Zero key which is followed by a "beep". Lift the sensor for more than
5cm. Then press the Zero key again and the gauge will return into measurement
mode. Now factory setting is restored.
Annotation:
To have a look at the CE Declaration of Conformity, please click onto the following
link:
https://www.kern-sohn.com/shop/de/DOWNLOADS/
6
TC_car-BA-e-1712
Advertisement
