Getting Started - Shark Pro Steam Pocket SE450 Series Owner's Manual

GETTING STARTED

When assembling your Steam Mop there
may be a little water in or around the water
tank. This is because we test all our Steam
Mops before you buy them, so you get a
quality Shark® Pro Steam Pocket® Mop.
a
c
d
f
e
a Steam Mop Body
b Mop Handle
c 2 Rectangle Mop Heads included
d Dirt Grip® pocket pad
e Filling Flask
f (1) 6mm x 54mm Large Screw*
* Phillips-head or flat-head screwdriver can
be used. Screwdriver not included.
6 s h a r kc l e a n . c o m
g
h
b
k
i
j
g Quick Release Cord Holder
h Cord Clips
i Water Tank Cap
j Water Tank
k Steam Control Button
l Mop Head Release Button
l
l
IMPORTANT: ALWAYS make sure the Shark®
Pro Steam Pocket® Mop is UNPLUGGED
from the wall when not in use. NEVER fill
the mop, attach the mop head, or change
or remove the pocket pad when the mop
is plugged into the wall. To prolong the life
of your Steam Mop, we recommend using
distilled water. Make sure you only add
water to the tank. Chemicals or cleaning
solution may damage the appliance and
could be unsafe for you and your family.
1
2
fig. 1
ASSEMBLE
1 Insert the mop handle into the Steam
Mop body. Be sure the cord hook is
facing the back of the mop and the
handle is inserted past the line marked
on the pole. Secure handle in place with
the included screw and either a Phillips-
head or flat-head screwdriver (not
included). (fig. 1)
s h a r kc l e a n . c o m 7