1. Manuals
  2. Brands
  3. Shark Manuals
  4. Steam Cleaner
  5. S3101UKJR
  6. Owner's manual

Shark S3101UKJR Owner's Manual

Steam mop
Hide thumbs Also See for S3101UKJR:
Table of Contents

Advertisement

Quick Links

Download this manual
OWNER'S GUIDE
S3101UKJR

Advertisement

Table of Contents
loading

Related Manuals for Shark S3101UKJR

Summary of Contents for Shark S3101UKJR

  • Page 1 OWNER’S GUIDE S3101UKJR...

  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS For Household Use Only 1. Use the system only for its WHEN USING YOUR SHARK intended use. STEAM MOP, BASIC SAFETY 2. DO NOT use outdoors. PRECAUTIONS SHOULD 3. DO NOT leave the appliance ALWAYS BE FOLLOWED, unattended when plugged in. INCLUDING THE FOLLOWING: Always unplug the power cord from the electrical outlet when WARNING: not in use and before servicing. READ 4. DO NOT allow the appliance to ALL INSTRUCTIONS BEFORE be used as a toy. Close attention...
  • Page 3 11. DO NOT unplug by pulling on 22. Extreme caution should be power cord. To unplug, grasp exercised when using this the plug not the power cord. appliance to clean stairs. Do not use extension cords or 23. Never use steam mop without outlets with inadequate current microfibre pad attached. carrying capacity. 24. K eep your work area well lit. 12. DO NOT put any objects into 25. Store steam mop indoors in a cool, openings. Do not use with any dry place. opening blocked. 26. T o avoid circuit overload, do not 13. DO NOT put hands or feet under operate another appliance on the the steam mop. Unit gets very same socket (circuit) as the steam hot. cleaner. 14. Use ONLY on flat, horizontal 27. If an extension cord is absolutely surfaces. Do not use on walls, necessary, an extension cord counters or windows. rated a minimum of 15 ampere, 15. DO NOT use on leather, wax 14 gauge cord should be used.

  • Page 4: Quick Start

    Quick Start ASSEMBLE 1 Fit together the extension tubes as shown in the illustration. See page 2 for more detailed assembly instructions. 2 Place the microfibre cleaning cloth underneath the mop head, with quick fastener strips facing up. Simply press the pad to the mop to attach it. ADJUST 4 For your comfort, you can adjust the height of the mop. Just lift FILL the latch on the tube 90 degrees 3 Remove the cap to fill the to the open position. Holding Water Tank. Using the filling the handle, extend the tube to flask and funnel, fill the tank, the height that’s right for you keeping the water under the and then close latch to locked “MAX FILL” line. Don’t forget to position. replace the cap. QUICK TIP: If you find the Steam Mop difficult to push/pull during use, then simply increase the height of the pole.
  • Page 5 PRIME STEAM 5 Plug in the mop. Wait approximately 30 seconds for the unit to heat up and the steam QUICK TIP: Customise to be ready. steam output by slow or fast Push the handle toward the mop mopping with a forward and head in a pumping motion. To backward motion. prime simply pump the handle 10-15 times to generate the steam.
  • Page 6 This guarantee does not affect your statutory rights. If this product proves unsatisfactory please contact our customer service department on freephone 0800 781 7831. THIS BOOK COVERS MODEL NUMBER: S3101UKJR 11 TECHNICAL SPECIFICATIONS Voltage: 220-240V., 50Hz. Power: 1550 Watts Not to be disposed of with other household waste.
  • Page 7 Contents Thank you for GETTING STARTED purchasing USING YOUR STEAM MOP the Shark CARE OF YOUR STEAM MOP Steam Mop. TROUBLESHOOTING ORDERING REPLACEMENT PARTS www.sharkclean.co.uk...

  • Page 8: Getting Started

    Getting Started When assembling your steam mop there may be a little water in or around the water tank. This is because we test all our steam mops 100% before you buy them, so you get a quality Shark ® Steam Mop. FIRST THINGS FIRST, YOU NEED TO YOUR SHARK STEAM MOP IS KNOW WHAT’S IN THE BOX YOU EASY TO ASSEMBLE JUST OPENED: 1 First remove all the parts from the a Upper Extension Tube package. We know you’re excited about the Shark Steam Mop, b Lower Extension Tube (Telescopic) but don’t plug it in until it’s fully c Steam Mop Base assembled and you’ve read all of the...
  • Page 9 Always attach the microfibre cleaning pad to the mop head or you may scratch your floor surface. Note: Plug supplied may vary depending on region. 3 Insert the pieces you assembled in IMPORTANT: Always make sure that Step 2 into the pump actuator (the your Steam Mop is unplugged from tube that leads to the tank). Push the wall before you attach the the extension tube assembly and microfibre cleaning pad. pump actuator together in until you hear it click into place. Insert cord into cord clip on the shaft of the steam-mop. www.sharkclean.co.uk...
  • Page 10 Getting Started PLACING THE MICROFIBRE PAD NOTE: Don’t be alarmed if the first time you use your Steam Mop, you 1 Place the microfibre cleaning cloth notice water inside the water tank or underneath the mop head, with drops of water in the packaging. It’s the quick fastener strips facing up. normal to see this water. Your Steam Simply press the pad on to the Mop was 100% tested in the factory Steam Mop. to ensure your safety and your floor’s IMPORTANT: Make sure you only happiness. If you see water in the add water to the tank. Chemicals or unit, it’s from these tests. cleaning solution may damage the To order additional Microfibre pads, appliance and could be unsafe for feel free to contact us at: you and your family. Freephone 0800 781 7831. www.sharkclean.co.uk...
  • Page 11 The water tank cap has an arrow to indicate the locked and unlocked position. Note: Plug supplied may vary depending on region. FILLING THE WATER TANK 2 The filling flask and funnel included with your Steam Mop make filling IMPORTANT: Before you fill up the the water tank as simple as getting a tank, make sure your Steam Mop is glass of water from the sink. Fill the unplugged from the wall. flask with water and use the funnel to 1 First, remove the water tank cap by pour it into the tank. Be sure to keep turning it counter clockwise to the the water under the MAX FILL line; unlocked position. See illustration just one flask of water is enough for for a visual explanation. your Steam Mop. See illustration for a visual explanation. 3 Replace the water tank cap by turning it clockwise to the locked position. www.sharkclean.co.uk...

  • Page 12: Using Your Steam Mop

    Using Your Steam Mop Now comes the part you’ve been waiting for – it’s time to use your steam mop. When you use your steam mop for the first time or haven’t used the unit in awhile, it may take a minute or two for the water to make its way through the pump and into the heater to create steam. Get it started by pumping the handle a few times. If you’ve waited a few minutes and you still don’t see any steam, reference the troubleshooting section on page 9. IMPORTANT: Your Steam Mop needs 1 Pull and twist the quick release cord holder to unwrap the power cord water to make steam! Never use completely. Plug into a 220-240 your Steam Mop without water in the volt electrical outlet. The “On” light tank. will turn green. Success! If your Sweep or vacuum your floors light doesn’t turn on reference the before using your Steam Mop. Your Troubleshooting section on page 9. Steam Mop was designed to get 2 For your comfort, you can adjust the rid of stuck-on gunk, grime, paw/ height of the mop. Just lift the latch footprints and it will do a better job on the tube 90 degrees to the open if yesterday’s cereal crumbs aren’t in position. Holding the handle, extend the way. the tube to the height that’s right for you and then close latch to locked position.
  • Page 13 When your Steam Mop stops steaming, it could be out of water. Unplug the power cord from the electrical outlet and refill the water tank at anytime. 3 It takes about 30 seconds for the IMPORTANT: When your floors are steam to get going. Now pump sparkling clean and you’re finished the handle a few times to prime the with your Steam Mop, unplug it from pump and activate steam. the electrical outlet and carefully remove the microfibre cleaning pad 4 Mop with a forward and backward from the mop head. Always remove motion to customise steam output the microfibre cleaning pad from the automatically. mop head when you have finished QUICK TIP: If you find the Steam using your Steam Mop to avoid Mop difficult to push/pull during use, damage to your floors. The steam then simply increase the height of will make your microfibre cleaning the pole. pad very hot. You may want to wait a couple of minutes to let it cool off before you remove it. www.sharkclean.co.uk...

  • Page 14: Care Of Your Steam Mop

    Care of Your Steam Mop Always remove the microfibre cleaning pad from the Steam Mop head when you store your Steam Mop to avoid damage to your floors. 40° KEEPING YOUR MICROFIBRE KEEPING YOUR STEAM MOP CLEANING PAD AS GOOD AS NEW IN TIP-TOP SHAPE Your steam activated microfibre If you love your Steam Mop, let it cleaning pad works wonders for you, show. Caring for your Steam Mop so return the favour by giving it the and properly storing it means you’ll care it deserves. get the same super steam action you expect each time you use it. 1 Wash pad in warm water. Wash separately from other laundry. IMPORTANT: Both your Steam Mop and the water inside it can get very Only use liquid detergent (no powder hot, so let it cool down completely...

  • Page 15: Troubleshooting

    Trouble Shooting PROBLEM POSSIBLE REASONS & SOLUTIONS Your steam-mop should be securely plugged into a The Steam Mop 220-240V electrical outlet only. will not turn-on. Check your fuse or breaker. Steam Mop will not Is there water in the water tank? If not, add water to your make steam. Steam Mop following instructions. Is your microfibre cleaning pad too wet? Why don’t Steam Mop leaves you unplug your Steam Mop and change the microfibre water on the floor. cleaning pad. Don’t leave your steam-mop on the floor with a damp or Steam Mop left white wet cleaning pad. spot on the floor.

  • Page 16: Ordering Replacement Parts

    Ordering Replacement Parts ORDERING REPLACEMENT PARTS PART PART NO. To order additional parts and a 2 Microfibre Pads XT3250APUKJR accessories, feel free to contact us at: b Carpet Glider XCG3101UKJR Distributed by JML JML, Unit 1 Eastside Port of Tyne South Shields NE33 5SP info@JMLgroup.co.uk Freephone 0800 781 7831 www.sharkclean.co.uk...
  • Page 17 This appliance complies with the WEEE-Directive 2002/96/EC on the disposal of electrical and electronic equipment (WEEE). This appliance complies with the European directives for electromagnetic compatibility (EMC) 2004/108/EC and its revisions, as well as Low Voltage Directive (LVD) 2006/95/EC and its revisions. T his marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material sources. To return your used device, please use the return and collection systems or contact the retailer where this product was purchased. They can take this product for environmental safe recycling. www.sharkclean.co.uk...
  • Page 18 Notes www.sharkclean.co.uk...
  • Page 19 Notes www.sharkclean.co.uk...
  • Page 20 Distributed by JML JML, Unit 1 Eastside Port of Tyne South Shields NE33 5SP info@JMLgroup.co.uk Freephone 0800 781 7831 www.sharkclean.co.uk Registered address: JML House, NW5 3EG Technical Details Model number: S3101UKJR 11 Input: 1550 Watts Main unit voltage: 220-240 V., 50 Hz Not to be disposed PRINTED IN CHINA of with other household waste. IPX4 S3101UKJR.E.101004 Illustrations may differ from actual product.

Table of Contents