Safety Advice; General Maintenance - Flexlite 3H User Manual

WARNING:
Keep the charger and the work light out of reach of children.
WARNING:
Do not try to open charger or work light. No parts can be changed by user. To replace battery, return work light and charger to an
authorized service center.
IMPORTANT INFORMATION FOR
RECHARGING A HOT WORK LIGHT
When using the work light continuously, the batteries in the battery pack will become hot. You should let a hot battery pack
cool down for approximately 30 minutes before attempting to recharge.
NOTE: Refer to "CHARGING THE BATTERY" for normal recharging of batteries. If the charger does not charge your
battery pack under normal circumstances, return both the battery pack and charger to your nearest repair center for electrical
inspection. For the location of your nearest repair center, please call 1-866-854-1411.
Use « Touch Pad » switch in front of the light head:
TO TURN WORKLIGHT ON:
DIM FROM 40% TO 70%:
DIM FROM 70% TO 100%:
FLASHING MODE:
TURN OFF:
Push and hold 1/2 second anytime

SAFETY ADVICE


If the light head come too hot, an integrated electronic device will turn down the light power at 25% of efficiency
on blinking mode. If the temperature still increases, the device will cut off the light automatically. Ensure the heat
sink is clean. If the problem persists, return the work light to an authorized service center.

When the battery becomes discharged, the light head will automatically turn down the light power at 25% of
efficiency to allow to the user several minutes to leave the dark area.
MAINTENANCE
WARNING:
When servicing use only identical FLEXLITE
replacement parts. Use of any other parts may
create a hazard or cause damage to the product.
WARNING:
Always wear safety goggles or safety glasses
with side shields when using compressed air to
clean work lights. If operation is dusty, also
wear a dust mask.
Push and hold 1/2 second.
Push quickly one time.
Push quickly another time.
Push quickly another time
.
.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals
can damage, weaken or destroy plastic which
may result in serious personal injury.
7