General Safety Rules; Work Area; Storage Temperature - Flexlite FLX3T Operator's Manual

GENERAL SAFETY RULES

WARNING!
READ AND UNDERSTAND ALL INSTRUCTIONS.
Failure to follow all instructions listed below may result in electric shock, fire and/or serious personal injury.
SAVE THESE INSTRUCTIONS

WORK AREA

Keep your work area clean and well lit. Cluttered benches
and dark areas invite accidents.
Working temperature. This worklight is designed to be
used at normal room temperature. If used under 0°C (32°F)
the battery will discharge faster. If used over 45°C (113°F)
an automatic cut-off will turn the light off until the
temperature of the light head comes down. Depending on if
the work area is closed, with or without a fresh air draft, the
cut-off temperature can be affected (see Features for more
information).
FLEXLITE is designed to be used in an industrial
environment in rain, snow and dust, but FLEXLITE products
can not be immersed in water. If the working area is moist
and dusty, some particles will stick on the fan or heatsink and
reduce the performance. See maintenance section to remove
any dirt.
Don't operate FLEXLITE in sunshine or near to other heat
sources.
The power supply should be protected with an optional
sealed case. It can't be used outside or in rain, moisture,
snow, ...
DANGER!
Never connect / disconnect or use an external power supply
or charger in a hazardous area.
DANGER!
Never connect or disconnect the connector on the lighthead or
any extension cord when the power is on or when use in
hazardous area.
SERVICE
Worklight service must be performed only by qualified
repair personnel. Service or maintenance performed by
unqualified personnel may result in a risk of injury.
When servicing a worklight,
replacement parts.
Maintenance section of this manual. Use of unauthorized
parts or failure to follow Maintenance Instructions may
create a risk of shock or injury

STORAGE TEMPERATURE

Store worklight at room temperature between -35°C and
35°C (-31°F and 95°F) for best results.
When transporting or temporarily storing in a vehicle,
temperature range should be between -35°C(-31°F) and
66°C(151°F).
Storing worklight at temperatures greater than 76°C
(169°F) for extended periods of time (more than 2 hours)
may cause damage to worklight.
DANGER!
Don't use the power supply outside without protection cabinet
IP66.
use only identical
Follow instructions in
.
the
2