ASSEMBLY
UNPACKING
This product has been shipped completely assembled.
Carefully remove the work light and any accessories from the
box. Make sure that all items listed in the packing list are
included.
Inspect the work light carefully to make sure no breakage or
damage occurred during shipping.
Do not discard the packing material until you have carefully
inspected and satisfactorily operated the work light.
If any parts are damaged or missing, please call
1-866-854-1411 for assistance.
PACKING LIST
Work light harness
Operator's Manual
Charger
WARNING:
If any parts are missing, do not operate this work light
until the missing parts are replaced. Failure to do so
could result in possible serious personal injury.
OPERATION
WARNING:
Do not allow familiarity with work lights to make you careless. Remember that a careless fraction of a second is sufficient to
inflict serious injury.
WARNING:
Do not use any attachments or accessories not recommended by the manufacturer of this work light. The use of attachments or
accessories not recommended can result in serious personal injury.
CAUTION:
To prevent damage to the built-in battery, remove from the charger immediately if no LED comes on. Return the
work light and charger to your nearest service center for maintenance or a replacement.
CHARGING THE BATTERY
Battery for this work light is shipped in a low charge condition to prevent possible problems. Therefore, you should charge
the battery until the light in front of the charger turns green.
TO CHARGE
Charge the battery pack only with the recommended chargers (See « FEATURES » section on page 5).
Connect the charger to a power supply.
Turn off the light, connect the charger barrel Jack into the outlet under the battery device or clip on the battery pack inside the optional
wall mount charger.
After normal usage, a minimum of 4 hours of charging time is required to be fully charged.
The charger will become slightly warm to the touch while charging. This is normal and does not indicate a problem.
Do not place the charger in an area of extreme heat or cold. It will work best at normal room temperature.
When the batteries become fully charged, unplug the charger from the power supply.
The charger will cut off automatically if battery is fully charged as indicated by LED :
Charging :
solid red LED
Battery full : solid green LED
Error status : flashing red LED
WARNING:
Do not attempt to modify this work light or create
accessories not recommended for use with this
work light. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING:
Never disconnect the connector on the light head
unit when power is turned « on ».
WARNING:
Keep FLEXLITE out of reach of children. The
work light may cause serious injuries. To avoid
possible strangulation, keep harness away from
children. This work light is not a toy.
6