Storage Temperature; Specific Safety Rules - Flexlite 3H User Manual

batteries or a separate battery pack must be recharged
only with the specified charger for the battery. A charger
that may be suitable for one type of battery may create a risk
of fire when used with another battery.
 Use charger only with products listed (refer to
FEATURES on page 5).
SERVICING
 Work light maintenance must be performed only by
qualified repair personnel. Servicing or maintenance
performed by unqualified personnel may result in a risk of
injury.

When servicing a work light, use only identical
replacement parts. Follow
Maintenance section of this manual. Use of unauthorized
parts or failure to follow Maintenance Instructions may
create a risk of shock or injury

SPECIFIC SAFETY RULES

DANGER!
Chest battery models, remove battery from the pouch
for charging.
 Know your work light. Read operator's manual carefully.
Learn its applications and limitations, as well as the
specific potential hazards related to this work light.
Following this rule will reduce the risk of electric shock, fire,
or serious injury.
 Lens and housing become hot during use:
 During or immediately after use, don't lay work light flat
on lens surface or place lens area in contact with a plastic
or fabric covered surface.
 Handle work light with care around any flammable
surface.
 Do not use or permit use of work light in beds or sleeping
bags. This work light lens can melt fabrics and a burn
injury could result.
 Use only the charger recommended for use with your
work light. Do not substitute any other charger. Use of
another charger could cause batteries to explode causing
possible serious injury.
WARNING!
MAGNETIC HAZARDS
Strong magnetic forces pose a potential hazard to people who wear heart implant devices and they can destroy magnetic media
data files (such as computer hard drives). Visually warning people of the existence of strong magnetic fields is necessary when
such fields are generated by equipment.
WARNING!
LED LIGHT
Do not stare into the beam or view directly with or without optical instruments.
WARNING!
This light system needs a constant air flow to cool down, NEVER leave the light turned on when not in motion;
otherwise the light will becomes hot and can cause injury, fire or damages. Do not project the light towards traffic
road, another person or any vehicle to prevent blindness. Doing so, may result in serious injuries or death.
instructions in the
.

STORAGE TEMPERATURE

 Store work light at room temperature between 4 and 27°C
(40 and 80°F) for best results.
 When transporting or temporarily storing in a vehicle,
temperature range should be greater than -30°C (-22°F) but
no more than 66°C (151°F).
 Storing work light at temperatures greater than 76°C
(169°F) for extended periods of time (more than 2 hours)
may cause damage to work light and possible fire or
explosion.
DANGER!
Never store FLEXLITE (battery models) in direct
sunlight.
 Do not charge battery pack in a damp or wet location.
Following this rule will reduce the risk of electrical shock.
 Your battery work light should be charged in a location
where the temperature is more than 10°C (50°F) but less
than 37°C (99°F).
 Do not disassemble your work light.
 Do not permit children to use work light unsupervised. It
is not a toy. The temperature of the light head will become
hot after being on for only a short period of time. This hot
temperature can cause burn injuries if touched and can create
sufficient heat to melt some fabrics.
 Stay alert. Watch what you are doing and use common
sense. Do not rush.
 If wrapped or in contact with fabrics, the work light lens
can produce sufficient heat to melt some fabrics. To avoid
serious personal injury, never allow the work light lens to
come in contact with anything.
 Check damaged parts. Before further use of this work light,
a part that is damaged should be carefully checked to
determine that it will operate properly and perform its
intended function. Do not use work light if it does not
function properly.
3