Safety Advice; General Maintenance - Flexlite FLX24L2H Operator's Manual

IMPORTANT INFORMATION FOR
RECHARGING A HOT WORKLIGHT
When using the worklight continuously, the batteries in
the battery pack will become hot. You should let a hot
battery pack cool down for approximately 30 minutes
before attempting to recharge.
Use « Touch Pad » switch in front the lighthead:
TO TURN WORKLIGHT ON:
DIME FROM 100% TO 50%:
DIME FROM 50% TO 25%:
FLASHING MODE:
TURN OFF:
Push and hold 2 seconds anytime

SAFETY ADVICE

If the light head come too hot, an integrated electronic device will turn down the light power at 25% of efficiency
on blinking mode. If the temparature still increase, the device will cut off the light automatically. Verify if the
heatsink is clean. If the problem persists, retrun the worklight to authorized service center.
When the battery becomes discharged, the light head will automatically turn down the light power at 25% of
efficiency to allow to the user several minutes to leave the dark area.
MAINTENANCE
WARNING:
When servicing use only identical FLEXLITE
replacement parts. Use of any other parts may create
a hazard or cause product damage.
WARNING:
Always wear safety goggles or safety glasses with
side shields when using compressed air to clean
worklights. If operation is dusty, also wear a dust
mask.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most plastics
are susceptible to damage from various types of commercial
solvents and may be damaged by their use. Use clean cloths to
remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc., come in
contact with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal injury.
Push and hold 2 seconds
Push quickly one time.
Push quickly another time.
Push quickly another time
NOTE: Refer to "CHARGING THE BATTERY" for
normal recharging of batteries. If the charger does not
charge your battery pack under normal circumstances,
return both the battery pack and charger to your nearest
repair center for electrical check. For the location of your
nearest repair center, please call 1-866-854-1411.
.
.
.
BATTERIES
This worklight is equipped with Li-Ion Polymer rechargeable
batteries. Length of service from each charging will depend on
the type of work you are doing. The batteries in the housing
have been designed to provide maximum trouble-free life.
However, like all batteries, they will eventually wear out. Do
not disassemble housing and attempt to replace the batteries.
Handling of these batteries, especially when wearing rings and
jewelry, could result in a serious burn. Battery Life: Batteries
that lose 20% of their capacity must be removed from service
and disposed of properly. Return FLEXLITE to your servicing
center to replace the battery.
FAN AND/OR HEATSINK
MAINTENANCE
These Flexlite are made with an integrate cooling fan. Design to
resist rain and dust. This fan and air flow heatsink must be
clean frequently to perform. Use only a
low air pressure gun to clean and remove any dust. Don't use
solvent, soap or cleaner. The unit is clean when you can see
across the heatsink.
WARNING:
Do no Do not immerse in water.
7