Table of Contents
Advertisement
OPERATION
Use « Touch Pad » switch in front of the lighthead :
TO TURN WORKLIGHT ON:
DIM FROM 100% TO 50%:
DIM FROM 50% TO 25%:
FLASHING MODE:
TURN OFF:
Push and hold 2 seconds at
Installation suggestion:
FLX3M and FLX3C come with a sticky pad to increase the performance of the magnet or c-clamp. Remove
protection before finally installing your
SAFETY ADVICE
If the light head becomes too hot, an integrated electronic device will turn down the light power to 25% of
efficiency on blinking mode. If the temparature still increases, the device will cut off the light automatically.
Verify if the heatsink is clean. If the problem persists, return the worklight to an authorized service center.
When the battery becomes discharged, the light head will automatically turn down the light power to 25% of
efficiency to allow to the user several minutes to leave the dark area.
Push and hold 2 seconds.
Push quickly once.
Push quickly another time.
Push quickly another time.
anytime.
FLEXLITE.
7
Advertisement
Table of Contents
