Operation; Charging The Battery - Flexlite FLX6SB User Manual

OPERATION

WARNING:
Do not allow familiarity with work lights to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this work light.
The use of attachments
recommended can result in serious personal injury.

CHARGING THE BATTERY

Battery for this work light is shipped in a low charge
condition to prevent possible problems. Therefore, you
should charge the battery for a minimum of 3 hours.
TO CHARGE
 Charge the battery pack only with the recommended
adapter.
 See « FEATURES » section on page 6.
 Connect adapter to the proper power supply.
 Turn off the light.
 After normal usage, minimum 3 hours of charging time
is required to be fully charged.
 Do not place the FLX6SB in an area of extreme heat or
cold. It works best at normal room temperature.
 When the batteries become fully charged, unplug the
charger from the power supply.
Use the switch in front of the housing to turn the light on/off.
or accessories not
 The charger will cut off automatically if battery is fully
charged.
WARNING:
Keep the wall mount charger and the work light out of
reach of children.
WARNING:
Do not try to open wall mount charger or work light.
No parts can be changed by user. To replace battery,
return work light and wall mount charger to authorized
service center.
IMPORTANT INFORMATION FOR
RECHARGING A HOT WORKLIGHT
When using the work light continuously, the batteries in
the battery pack will become hot. You should let a hot
battery pack cool down for approximately 30 minutes
before attempting to recharge.
NOTE: Refer to "CHARGING THE BATTERY" for
normal recharging of batteries. If the charger does not
charge your battery pack under normal circumstances,
return both the battery pack and charger to your nearest
repair center for electrical check. For the location of your
nearest repair center, please call 1-866-854-1411.
6