Brother MFC-230C User Manual page 111

c
Open the new ink cartridge bag for the
color shown on the LCD, and then take
out the ink cartridge.
d
Remove the protective yellow cap (1).
1
Improper Setup
DO NOT touch the area shown in the
illustration below.
Note
If the protective yellow caps come off
when you open the bag, the cartridge will
not be damaged.
e
Each color has its own correct position.
Insert the ink cartridge in the direction of
the arrow on the label.
M
brother
Troubleshooting and Routine Maintenance
f
Lift each lock release lever and push it
until it clicks, and then close the ink
cartridge cover.
g
The machine will automatically reset the
ink dot counter.
Note
• If you replaced an ink cartridge before the
LCD shows Near Empty or Ink Empty,
the LCD will ask you to verify that it was a
brand new one. (For example,
Did You Change Blck?) For each
new cartridge you installed, press 1 (Yes)
to automatically reset the ink dot counter
for that color. If the ink cartridge you
installed is not a brand new one, be sure
to press 2 (No).
• If the LCD shows No Cartridge after
you install the ink cartridge, check that the
ink cartridges are installed properly.
WARNING
If ink gets in your eyes, wash them out with
water at once and call a doctor if you are
concerned.
B
95