Packing And Shipping The Machine - Brother MFC-230C User Manual

Packing and shipping
the machine
When you transport the machine, use the
packing materials that came with your
machine. If you do not pack the machine
properly, you could void your warranty.
CAUTION
It is important to allow the machine to 'park'
the print head after a print job. Listen
carefully to the machine before unplugging
it to make sure that all mechanical noise
has stopped. Not allowing the machine to
finish this parking process may lead to print
problems and possible damage to the print
head.
a
Open the ink cartridge cover.
b
Pull the lock release levers down and
take out all the ink cartridges. (See
Replacing the ink
cartridges on page 94.)
102
c
Install the yellow protective part, lift each
lock release lever and push it until it
clicks, and then close the ink cartridge
B
cover.
CAUTION
If you are not able to find the yellow
protective parts, DO NOT remove the ink
cartridges before shipping. It is essential
that the machine be shipped with either the
yellow protective parts or the ink cartridges
in position. Shipping without them will
cause damage to your machine and may
void your warranty.
d
Unplug the machine from the telephone
wall jack and take the telephone line
cord out of the machine.
e
Unplug the machine from the AC power
outlet.
f
Using both hands, use the plastic tabs
on both sides of the machine to lift the
scanner cover until it locks securely into
the open position. Then unplug the
interface cable from the machine, if it is
connected.