Brother MFC-230C User Manual page 106

Error Message Cause
No Response/Busy The number you dialed does not
answer or is busy.
Not Registered You tried to access a Speed Dial
number that is not programmed.
The machine's memory is full.
Out of Memory
Paper is jammed in the machine.
Paper Jam
The machine has a mechanical
Print Unable
problem.
XX
—OR—
A foreign object such as a clip or
ripped paper is in the machine.
Scan Unable XX The machine has a mechanical
problem.
—OR—
A foreign object such as a clip or
ripped paper is in the machine.
Wrong Paper Size Paper is not the correct size.
A broken device has been
Unusable Device
connected to the USB direct
Disconnect device
interface.
from front
connector.
Turn the machine
off & on
by pressing
On/Off button on
control panel.
90
Action
Verify the number and try again.
Set up the Speed Dial number. (See Storing
Speed Dial numbers on page 45.)
Fax sending or copy operation in progress
Press Stop/Exit and wait until the other
operations in progress finish and then try again.
Printing operation in progress
Reduce print resolution. (For details, see
®
Printing for Windows or Printing and Faxing for
®
Macintosh in the Software User's Guide on the
CD-ROM.)
Remove the Jam Clear Cover (at the back of the
machine) and pull out the jammed paper. See
Printer jam or paper jam on page 92.
Open the scanner cover and remove any foreign
objects inside the machine. If the error message
continues, see Transferring your faxes or Fax
Journal report on page 91 before disconnecting
the machine so you will not lose any important
messages. Then, disconnect the machine from
the power for several minutes and then
reconnect it.
Open the scanner cover and remove any foreign
objects inside the machine. If the error message
continues, see Transferring your faxes or Fax
Journal report on page 91 before disconnecting
the machine so you will not lose any important
messages. Then, disconnect the machine from
the power for several minutes and then
reconnect it.
Load the correct size of paper (Letter, Legal or
A4), and then press Black Start or Color Start.
Unplug the device from the USB direct interface,
then press On/Off to turn the machine off and
then on again.