Bogen ANS1R Instruction Manual
  1. Manuals
  2. Brands
  3. Bogen Manuals
  4. Accessories
  5. ANS1R
  6. Instruction manual

Bogen ANS1R Instruction Manual

Ambient noise sensor output module
Hide thumbs Also See for ANS1R:
Table of Contents

Advertisement

Quick Links

Download this manual
ANS1R
Ambient Noise Sensor Output Module
© 2002 Bogen Communications, Inc.
54-2067-01B
0403
Specifications subject to change without notice.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ANS1R and is the answer not in the manual?

Questions and answers

Related Manuals for Bogen ANS1R

Summary of Contents for Bogen ANS1R

  • Page 1 ANS1R Ambient Noise Sensor Output Module © 2002 Bogen Communications, Inc. 54-2067-01B 0403 Specifications subject to change without notice.

  • Page 2: Package Contents

    ANS1R. AUX Level Control Controls the input source level when internal jumper is set to Bypass mode (AUX signal bypasses gain riding). Defeat The effects of the ANS1R will be defeated when these terminals are shorted together.

  • Page 3: Module Installation

    There are situations where it may be undesirable for this AUX input to be affected by the gain riding function of the ANS1R. A typical exam- ple would be where low level background music is desired in a lounge when there are only a few people present.

  • Page 4: Sensor Microphone Connections

    Physical connections can be made using either Home Runs back to the module from each sensor or by daisy-chaining sensors, depending on the installation.The maximum total wire length from sensor mics to the ANS1R must be kept below 2000 ft. Total Max Wire Length 2000 ft.

  • Page 5: Module Setup

    ANS1R.Therefore, the input applied to the ANS1R’s AUX input, in this mode, will be affected by the gain adjusting process just like all the other inputs in the unit.
  • Page 6 AMBNT THRES control to a point where the ACT LED flashes green. 6. Adjust the MAX GAIN to limit the maximum amount of gain the ANS1R can add to the system. 7. Adjust the RAMP SPEED control to the desired amount of signal gain per second (dB/s).

  • Page 7: Ambient Level Settings

    Ambient Level Settings Use this table to estimate the general dBspl level of the area’s ambient noise if no actual measurements are available. Ambient Threshold Control (Detailed Markings) Because of space limitations on the front panel, detailed calibration markings for the Ambient Threshold Control do not exist.

  • Page 8: Block Diagram

    Block Diagram 50 Spring Street, Ramsey, NJ 07446, U.S.A. Tel. 201-934-8500; Fax: 201-934-9832; www.bogen.com...

Table of Contents