Table of Contents
Advertisement
INSTALLATION
General
The Glo-Ray
merchandiser Warmer is shipped with most
®
components pre-assembled. Care should be taken when
unpacking shipping carton to avoid damage to unit and
components enclosed.
WARNING
ELECTRIC SHOCK HAzARD: Unit is not weatherproof.
Locate unit indoors where ambient air temperature is a
minimum of 70°F (21°C).
FIRE HAzARD: Locate unit a minimum of 1" (25 mm) from
combustible walls and materials. If safe distances are not
maintained, discoloration or combustion could occur.
CAUTION
Locate unit at proper counter height in an area that is
convenient for use. Location should be level to prevent
unit or its contents from falling accidentally and strong
enough to support weight of unit and contents.
NOTE: Unit must be transported in the upright position.
1. Remove the unit from the carton.
2. Remove tape and protective packaging from all surfaces of
the unit and any accessories.
NOTICE
Do not lay unit on the side with the control panel. Damage
to the unit could occur.
Do not drag or slide unit when moving or installing.
Carefully lift unit to prevent the rubber feet from tearing
off.
3. Place the unit in the desired location.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 70°F (21°C).
avoid areas that may be subject to active air movements
or currents (i.e., near exhaust fans/hoods and air
conditioning ducts).
• make sure the unit is at the proper counter height in an
area convenient for use.
• make sure the countertop is level and strong enough to
support the weight of the unit and food product.
• make sure all the feet on the bottom of the unit are
positioned securely on the countertop.
Assembly
Position the unit upright on the counter near the location it will
be used. Installation of the following items is required before
operating the unit:
Qty. Item
2
Glass Side Panel, P/N 04.40.294.00
1
Polycarbonate Sneeze Guard, P/N 04.12.326.00
Installing the Side Panels
Use the following procedure to install the side panels.
1. Remove the thumbscrew and the top bracket from the top
frame.
2. Position the side panel so that the curved edge is facing the
front of the unit.
3. Carefully lower the bottom edge of the side panel into the
bottom bracket.
Do not allow the side panel to drop into position. Chipping
or breakage could occur. Carefully set the side panel into
the bottom bracket.
4. make sure the back edge of the side panel is against the
vertical support, and tilt the top edge of the side panel
against the top frame.
5. Place the top bracket over the top edge of the side panel and
thread the thumbscrew through the hole in the bracket and
into the top frame. Tighten securely, but do not over-tighten.
6. Repeat the above procedure to install the other side panel.
Installing a Side Panel
Installing the Sneeze Guard
Use the following procedure to install the sneeze guard on
single front door units.
1. Remove any protective paper from the polycarbonate
sneeze guard.
2. Remove the six thumbscrews and washers from the top of
the unit.
3. Position the sneeze guard on top of the unit, aligning the
holes in the sneeze guard with the holes in the standoffs on
top of the unit.
4. Place a washer (previously removed) in each sneeze guard
hole.
5. Secure the sneeze guard using the thumbscrews. Do not
over-tighten.
Thumbscrew
Sneeze
Guard
Installing the Sneeze Guard
6
CAUTION
Top Frame
Top Bracket
Thumbscrew
Side Panel
Vertical Support
Washer
Standoff
Form No. GRCmWDm-0412
Advertisement
Table of Contents
