Before Use - BorMann BGC1350 Manual

or if it bounces. This can cause a loss of control
or kickback.
e) Do not use a toothed or chain saw blade or
segmented diamond-coated disc with more
than 1 0 mm wide slits. Such accessory tools
cause a kickback or loss of control over the
power tool.
f) Avoid cutting disc jams or excessive contact
pressure. Do not make any excessively deep
cuts. Overloading the cutting disc increases the
stress and likelihood of tilting or jamming and
thus the possibility of kickback or breakage of
the grinding tool.
g) If the cutting disc jams or you stop working,
switch the tool off and hold it steady until the
disc has completely slopped turning. Never
attempt to pull a rotating cutting disc out of a
cut. This could lead to kickback. Identify and
remove the cause of the jam.
h) Do not switch the power tool back on as long
as it is in the workpiece. Allow the cutting disc
to reach its full speed before you carefully
continue the cut. Otherwise, the disc may jam,
jump out of the workpiece or cause kickback.
i) Support panels or large workpieces to reduce
the risk of the cutting disc jamming and causing
a kickback. Large workpieces can bend under
their own weight. The workpiece must be sup­
ported on both sides, namely in the vicinity of
the cut and also at the edge.
j) Be particularly careful when making "pocket
cuts" into existing walls or other obscured
areas. The inserted cutting disc may cut into
gas or water pipes, electrical wiring or other
objects that can cause kickback.
Supplementary notes
Approved cutting disc designs:
Diamond-coated, disc diameter 125 mm, disc
thickness max. 2.2 mm
• "
(t)
Wear hearing protection!
Wear safety goggles!
Wear safety shoes!
8
Wear protective gloves!
(t
Wear a dust mask!
®
Not approved for wet grinding!
Original accessories/auxiliary equip­
ment
■ Only use the accessories and additional equip­
ment that are specified in the operating instruc­
tions and are compatible with the appliance.

Before use

Setting the groove depth
♦ Loosen the locking screw
♦ Set the depth stop f) to the desired depth.
♦ Tighten the locking screw
Attaching the dust extraction ad­
apter
♦ Push the pins of the dust extraction adapter
into the recesses on the dust extraction connector.
♦ Lock the dust extraction adapter
it.
♦ Loosen the union nut�-
♦ Push the pipe of the extraction device far enough
into the opening on the union nut�-
♦ Tighten the union nut� fully.
0.
0.
8
8
by turning