LAVOR Pro Reno Manual page 16

Safety
the machine
from being started unintentionally.
• Never direct the jet towards yourself or
any other person to clean clothing or
footwear.
• Never allow children or persons
without the necessary skills to operate
the machine.
CAUTION: Do not leave the appliance
•
in standby mode for more than 5
minutes.
• CAUTION: Always switch off the
appliance completely (main switch (0)
OFF) whenever leaving it unattended.
CAUTION: This machine uses high-
•
pressure fluids. Always grip the gun
2 firmly to counteract the recoil.
Only use the nozzles supplied with the
machine.
CAUTION: The appliance is not to
•
be used by children or persons with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been
EN
given supervision or instruction.
CAUTION: Children being supervised
•
16
not to play with the appliance.
Additional safety information
Water supply
• See chapter "Technical specifications".
• Only use clean water.
Water supply connection
Caution - Danger!
Only clean or filtered water should be used
for intake. The water intake should be at
least twice the pump capacity.
- Minimum delivery rate: 15 l/min
- Maximum intake water temperature:
40°C
- Max inlet water pressure: 1MPa
Place the cleaner as close as possible to
the water supply.
Water supply from the water main
• Connect a supply hose (not included)
to the water inlet of the unit and to the
water supply.
• Open the water supply.
The cleaner can be connected directly to
the mains drinking water supply only if
the supply hose is fitted with a backflow
preventer valve as per current regulations
in force.
Make sure that the hose is at least Ø
13mm and that it is reinforced.
Water supply from an open container
• Unscrew the coupling part for the
water inlet.
• Screw the suction hose with filter (not
included) onto the water connection
of the unit.
• Hang the filter in the container.
• Vent the unit before operation.
- Unscrew the high-pressure line
at the high-pressure outlet of the
unit.
- Switch on the unit and let it
run until water free of bubbles
emerges at the high-pressure
outlet.
- Switch off the unit and screw on
the high-pressure hose again.
Caution: Failure to observe the
above conditions will cause serious
mechanical damage to the pump and
will void the guarantee.
High-pressure hose
Caution: The high-pressure hose
has been specially designed to resist
high pressures. Treat with particular
care to prevent damaging it.
• Avoid tangling.
• Do not bend the hose or subject it to
high stress or strain
• Never start the high-pressure cleaner
without first completely unwinding
the high-pressure hose
• Before unwinding or winding the
hose, switch the machine off and
release the pressure in the hose
itself (pull spray gun trigger 25 2-3
times).
Caution: Inappropriate use may cause
damage or untimely breakage and
voids the guarantee.
3
3 .