BorMann Technik BTC5000 Owner's Manual page 4

Sighting
Align the edge of the front of the base with your cutting line on the workpiece.
Operation
Hold the tool firmly, set the base plate on the workpiece to be cut without the wheel making any contact, then switch the
tool on and wait until the wheel attains full speed, now simply move the tool forward over the workpiece surface, keeping
it flat and advancing smoothly until the cut thing is completed, keep your cutting line straight and your speed of advance
until form.
4
Switch action
To start the tool simply pull the trigger.
Release the trigger to stop for continuous operation: Pull the
trigger and then push in the lock button.
To stop the tool from the locked position: Pull the trigger fully
then release it
Caution! Before plugging in the tool always check to see that
the switch trigger actuates properly and returns to the OFF
position when released
www.BormannTools.com