Table of Contents
Advertisement
Installing the cable management arm
Hardware Install Guide for FortiScan
http://docs.fortinet.com/
3 Grasp the sides of the system firmly and pull forward and up to unseat the system from
the J-slots. Lift the system up and away from the rack and place on a level surface (3).
Figure 19: Removing the system from the rack
3
2
The FortiScan-3000C comes with a cable management arm (CMA). Locate the
components for installing the CMA assembly:
•
cable management arm tray (1)
•
cable management arm (2)
•
nylon cable tie wraps (3)
Use the instructions below to install the CMA.
Note: To secure the CMA for shipment in the rack, loop the tie wraps around both
baskets and tray and cinch them firmly. For larger CMAs, the tie wraps can be
threaded through the inner and outer baskets and around the tray to secure them.
Securing the CMA in this manner will also secure your system in unstable
environments.
Caution: Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin,
review the safety instructions that came with the system.
Document feedback
•
1
25
Advertisement
Table of Contents
