Table of Contents
Advertisement
FortiScan-1000C
Hardware Install Guide for FortiScan
http://docs.fortinet.com/
Caution: Before installing the FortiScan unit in a rack, install front and side
stabilizers on stand-alone racks or the front stabilizer on racks joined to other
racks. Failure to install stabilizers accordingly before installing FortiScan in a rack
could cause the rack to tip over, potentially resulting in bodily injury under certain
circumstances. Therefore, always install the stabilizers before installing
components in the rack.
After installing FortiScan components in a rack, never pull more than one
component out of the rack on its slide assemblies at one time. The weight of more
than one extended component could cause the rack to tip over and may result in
serious injury.
Caution: Do not move racks by yourself. Due to the height and weight of the rack,
a minimum of two people should be used to perform this task.
•
Before working on the rack, make sure that the stabilizers are secured to
the rack, extended to the floor, and that the full weight of the rack rests on
the floor. Install front and side stabilizers on a single rack or front stabilizers
for joined multiple racks before working on the rack.
•
Always load the rack from the bottom up, and load the heaviest item in the
rack first.
•
Make sure that the rack is level and stable before extending a component
from the rack.
•
Use caution when pressing the component rail release latches and sliding a
component into or out of a rack; the slide rails can pinch your fingers.
•
Do not overload the AC supply branch circuit that provides power to the
rack.
•
Ensure that proper airflow is provided to components in the rack.
•
Do not step on or stand on any component when servicing other
components in a rack.
The FortiScan-1000C comes with a sliding rail kit. Locate the components for the rail kit
assembly:
•
Two sliding rail assemblies
•
Two chassis rail members
•
Two Velcro straps
•
Two cable management arm (CMA) attachment brackets
Use the instructions below to install the rails on racks with square or round holes.
To install in square-hole racks
1 Position the left and right rail end pieces of the rail module labeled FRONT facing
inward.
Document feedback
•
8
Advertisement
Table of Contents
