Table of Contents
Advertisement
Removing the system from the rack
Hardware Install Guide for FortiScan
http://docs.fortinet.com/
2 The latches engage automatically as the system is pushed into the rack and are
released by pulling up on the latches (2).
3 To secure the system for shipment in the rack or for other unstable environments,
locate the hard-mount screw under each latch and tighten each screw with a #2 Phillips
screwdriver (3).
To route the cables
1 Locate the inner and outer CMA brackets on the interior sides of both rack flanges (1).
Figure 18: Routing the cables
1
3
2 Bundle the cables gently, pulling them clear of the system connectors to the left and
right sides (2).
3 Thread the Velcro straps through the tooled slots on the outer or inner CMA brackets
on each side of the system to secure the cable bundles (3).
To remove the system from the rack
1 Locate the lock levers on the front ends of both inner rails (1).
2 Pull up on each lever into the release position to unlock (2).
Document feedback
•
2
24
Advertisement
Table of Contents
