Installation/Startup; Routine Operation - Satelec Acteon Mini LED III Supercharged User Manual

MLED III Supercharged U2
Central wavelength:
Intensity:
Maximum exposure time:
Temperatures:
Operation:
Storage:
Humidity:
Operation:
Storage:
Atmospheric pressure
IV – INSTALLATION/STARTUP
4.1 UNPACKING THE UNIT
On reception of the unit, look for any damage that may
have occurred during transportation.
If necessary, contact your supplier.
4.2 RECOMMENDATIONS
Check that the environmental conditions have been
complied with (ambient temperature between 10°C and
40°C and humidity between 30% and 75%).
4.3 INSTALLATION
Ensure that the unit is not installed adjacent to
or on top of any other equipment.
Do not place the power cord in a cable feedthrough or
cable cover.
Remove the protective caps from the handpiece, screw
the battery onto the handpiece and insert the sterilized
light guide into the handpiece.
Ensure that the light guide is properly inserted,
confirmed by a click.
Ensure that all the segments of the LCD screen are
present once the battery has been properly screwed
down.
Place the base on a hard and stable surface that is not
inclined by more than 5°.
Connect the AC adapter after ensuring that the voltage
indicated corresponds to the electrical installation
available in the dental practice.
Two audible beeps confirm that the lamp has been
V5:Mise en page 1 22/02/2010
455 – 465 nm correctly placed on its holder.
2000 mW/cm² ± 10% for The translucent holder base lights up in blue and starts
an active fiber diameter flashing, indicating that the battery is charging.
of 7.5 mm As soon as the battery is charged, the translucent holder
15 seconds (show 15) base stops flashing and the blue light remains
illuminated continuously.
+10°C to +40°C 4.4 OPERATING FOR THE FIRST TIME
-20°C to +70°C Before operating, it is essential that the sterilizable
accessories (light guide and protective shield) be
sterilized and that the unit base be disinfected (see
30% to 75% chapter concerning maintenance).
10% to 100%
condensation included 4.5 MODES AVAILABLE
The Mini LED SuperCharged has three modes you can
700hPa to 1060hPa choose by pushing the left button (Fig.2-6) :
-
-
-
4.6 EXPOSURE TIMES AVAILABLE
In these modes, you can choose different exposure
times.
By pushing the right button (fig.2-7), you can select the
following combinations:
- Fast-Cure mode:
- 3 seconds (show 03) ;
- 4 seconds (show 04) ;
- 5 seconds (show 05) ;
- 10 seconds (show 10) ;
- Pulse-Cure mode:
- 5 shots of 1 second (full power with emission of 5
- 10 shots of 1 second (full power with emission of 10
- Step-Cure mode:
- 6 seconds progressively and 3 seconds at full power
- 10 seconds progressively and 5 seconds at full power
V – ROUTINE OPERATION
The Mini LED SuperCharged is normally placed on its
holder. The first time you plug it into the battery it will
10
12:47 Page 10
Fast-Cure,
Pulse-Cure,
Step-Cure.
successive one second flashes with a rest of period of
250 ms between each flash) - (show 05);
successive one second flashes with a rest of period of
250 ms between each flash) - (show 10) ;
(show 09) ;
(show 15).