Table of Contents
Advertisement
Available languages
Available languages
Notes:
- The discharge hose (not supplied) must have a minimum diameter of 25 mm and must be rigid
and kink resistant to prevent crushing.
- To avoid leakages in the delivery line and get the best performance, ensure to seal the fittings
with Teflon.
Remarks: - All components of the discharge line must be compression-proof.
- All components of the discharge line must be professionally installed
- If the components are not compression-proof or if they are improperly installed, the pressure
line could burst during operation. Risk of injury from liquid spurting out!
4.4- Start-up
1. The pump must be installed in a vertical position: ensure that it is stable during operation.
2. The suction holes must never be obstructed. It is therefore preferable that the pump should never be
placed directly on the ground or on the bottom of the well, pond or vessel.
For example, use a brick to support the pump.
V. OPERATION
5.1- Intended use
1. This clear water pump is a submersible pump intended for domestic use.
The pump is not intended for artisanal, industrial and/or commercial uses (for ex. Public parks, sports
grounds ...)
2. The pump is designed for routine household uses such as gardening, irrigation systems, pumping water
from tanks, well...
It can be used to suck up clear water from flooded premises with particles in suspension that are less than
[see table II] in diameter. When used to dry out premises (for ex. cellar draining) it is recommended to
place the pump below floor level.
3. The pump is fully submersible: the immersion depth must not exceed [see table II].
4. The pump should not be used for:
- for sucking up liquids or materials that are corrosive, flammable/combustible, explosive r any other
dangerous liquid; fats, oils, sea water, dirty water and waste water (e.g. from toilet, industrial...)
- for swimming pool cleaning; in fountains or aquariums...
- for pumping or transferring water intended for human consumption or any other food liquids.
5. The pump must not be used for operations not described in this manual.
Any other use, other than that described in the instructions, is likely to damage the pump and to put the user
in serious danger.
6. The temperature of clear water sucked up should not exceed 35°C.
5.2- Operation - automatic functioning mode
Connect pump to mains power.
As this pump is an automatic water pump, it starts operating as soon as it is connected to the electricity
supply, even when there is no water.
Page 15 / 25
Advertisement
Table of Contents
